
Getting Started
Important Moderation Notice
This community is currently under full moderation, meaning all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you will receive an email outlining the reason(s). We have implemented full moderation to control spam. Thank you for your patience and participation.
Top Liked Posts
-
By Vee4By Siva4By Vee2/* */By fun4net1By Maksym1
DIA failover between P1 and P2 circuits
Hi community,
I have two links in my setup (Versa device) with SDWAN Priority for DIA traffic set to P1 and P2 accordingly. Also I have IP SLA monitor attached, so when P1 link is down, DIA traffic can go to P2.
The problem is when P1 is back online (again UP), I noticed that many sessions continue to work using P2 circuit and never failover back to P1 circuit automatically.
How can I achieve automatic failover for the event where P1 link is restored after the failure for DIA traffic?
Comments
-
Hi fun4net,
I think your observation is related to existing sessions only. They will stay on P2 link unless they finished or P2 link goes down. All new sessions should be established via P1 link if it's alive.
Generally DIA sessions would leverage CGNAT, so switching existing session from one (alive) link to another would mean dropping and re-establishing this session, which may not be wanted behavior.